Signal Isolators

The Fusion range of Signal Isolators are compatible with ASI, 3G-SDI, HD-SDI, and SD-SDI digital video signals and also AES3 and MADI digital audio standards.

These high quality signal isolators employ an isolation transformer for superior performance and high breakdown voltages. They are used as a solution to provides reduction and elimination of hum and noise. This noise can interfere with digital transmission. It is caused by the difference in ground potential, especially those above 20 volts, or induced currents in long cable runs.

This common mode noise results in the degradation of the bit timing of high speed digital signals. This leads to bit errors. These bit errors will reduce the quality of the audio or video and their data content within the transmission signal. Digital signals do not degrade gracefully as they often suffer from a cliff effect. This will cause the digital signal to be lost altogether.

However, the singular most common symptoms of hum in digital signals is intermittent horizontal black streaks. These streaks are often one line in thickness. In audio, clicks and pops are often the symptom.

The signal isolators can also provide crucial ground protection. This occurs when ground or earth potential differences exist between equipment. These potential differences often result in permanent damage to video equipment. This damage can be costly and take a crucial video signal off-air. Versions for 1kV, 2kV and 4kV isolation are available. The 4kV unit is ideal for non broadcast applications such as industrial, medical, oil and gas.

The signal isolators by Fusion have high bandwidth performance and low insertion losses.

signal isolators

 

Digital Video Signal Isolators
DVIT75 Range

The DVIT75 range of signal isolators can be used for ASI, 3G-SDI, HD-SDI and SD-SDI digital video signals. They can be used for other signal types and will operate with all data rates between 100Mb/s to 3Gb/s. The range includes both compact standalone and rack mountable units.

signal isolators

 

Video Signal Isolator
AVIT75

The AVIT75 signal isolator can be used for all baseband video signals including composite (CVBS), RGB and YUV. They can be used for other signal types and will operate with all frequencies between 20Hz and 11MHz. The unit can be used as both standalone and rack mountable.

signal isolators

 

Digital Audio Signal Isolators
DAIT75 Range

The DAIT75 range of signal isolators can be used for AES3 and MADI digital audio signals. They can be used for other signal types and will operate with all data rates between 500kb/s to 500Mb/s. The range includes both compact standalone and rack mountable units.

UA-75478824-1